Jwin CD Player JX CD339 User Manual

Please read this manual thoroughly before operating your new CD player.  
IMPORTANT NOTES  
Avoid installing the unit in locations described below.  
Places exposed to direct sunlight or close to heat radiating appliances such as electric  
heaters.  
On top of other stereo equipment that radiates too much heat.  
Places lacking ventilation or dusty places.  
Places subject to constant vibration.  
Humid or moist places.  
MODEL #JX-CD339  
This product utilizes a laser.  
Danger - invisible laser radiation is present when unit is opened and interlock failed or  
defeated.  
Caution - Use of the controls or adjustments of procedures other than those specified herein  
may result in hazardous radiation.  
PERSONAL COMPACT DISC PLAYER  
THIS LASER COMPACT DISC PLAYER FUNCTIONS BY HELP OF INVISIBLE LASER  
LIGHT AND IS EQUIPPED WITH SAFETY SWITCHES TO AVOID EXPOSURE WHEN  
DOOR IS OPEN AND SAFETY INTERLOCKS ARE DEFEATED. IT IS DANGEROUS TO  
DEFEAT OR BY PASS SAFETY  
SWITHCES.  
INSTRUCTION MANUAL  
EN-1  
 
CHARGING AND USE OF RECHARGEABLE BATTERIES  
Rechargeable Battery Operation  
POWER SOURCES NORMAL BATTERIES / AC ADAPTOR  
Battery Power Operation  
AC Adaptor Operation  
(DC 4.5V 500mA AC adaptor  
not supplied )  
1. Open the battery compartment  
cover and insert two AA”  
alkaline batteries inside the  
battery compartment. Follow  
the polarity as indicated in the  
battery compartment.  
This unit can fully recharge the specified rechargeable battery, in approximately  
15 hours. The rechargeable batteries (NOT supplied) should be recharged before  
they are used form the first time because they are low in power or if they have not  
been used for a long period (over 60 days)  
1. Insert the DC plug, at the  
end of the AC adaptor cord  
into the DC input socket, at  
the back of the unit.  
1.Open the battery compartment cover and insert two of the recommended  
rechargeable batteries, matching polarity. (1.2V 650mA)  
2. Close the battery compartment  
cover.  
2. Plug the AC adaptor into a  
AC power outlet socket.  
ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM OR  
NI-MH TYPE, OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK.  
2. Plug in the AC adaptor (DC 4.5V 500mA) and set the Recharge switch to ON  
position to start charging. During charging the RED LED charge indicator will  
illuminate.  
3. After 15 hours. Please unplug the AC adaptor and switch the Recharge switch to  
the OFF position.  
DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO  
CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES  
TO DETERIORATE.  
Note: When the unit is to be  
operated using batteries, always  
unplug the AC adaptor from the AC  
power outlet and the DC input socket  
from the set. Otherwise the player  
will not operate.  
Note: You may play DISC'S whilst charging the batteries.  
4. If the operating time decreases drastically even when the rechargeable batteries  
are properly recharged, purchase a new set of rechargeable batteries.  
5. When charging for the first time or after a long time, playing time may be reduced.  
In this case, charge and discharge the batteries several times.  
3. (a) Do not mix old and new  
batteries.  
(b) Do not mix alkaline, standard  
(carbon-zinc) or rechargeable  
(nickel-cadmium) batteries.  
4. If the unit is not to be used for an  
extended period of time, remove  
the batteries. Old or leaking  
batteries can cause damage to  
the unit and may void the  
warranty.  
EN-4  
EN-5  
 
HEADPHONE AND HI FI CONNECTION  
BASIC DISC PLAY  
1. Connect the Headphones to the  
Listening with the  
NOTE: This player plays not only  
commercial CDs but also  
Connecting to component  
PHONES ( GREEN ) socket.  
2. Slide the OPEN switch to open the  
CD compartment lid.  
3. Adjust the VOLUME to minimum.  
4. Insert the disc with the label side  
facing up.  
5. Close the lid securely until a click  
is heard.  
6. Press the PLAY button to start  
playing.  
headphones  
audio systems  
self-compiled CD-R/RW disc.  
Connect the plug of the stereo  
headphones ( included ) into the  
PHONES ( GREEN ) socket.  
Connect the stereo connection  
cable ( not included ) into the  
LINE OUT ( BLACK ) socket of  
the unit and the CD / AUX inputs  
of an audio system.  
6
Caution: Avoid excessive volume  
levels for a long period of time when  
using headphones, as this may  
impair your hearing.  
Note: Always switch the power off  
before making any connections  
between the player and another unit.  
1
3
2
7. Adjust VOLUME for desired level.  
Caution:  
5
Avoid excessive volume levels while  
listening to sound for a long period of  
time when using headphones.  
4
TO CD/AUX  
INPUT  
To Emphasize the bass sound  
Set the DBBS switch to the ON  
position.  
Note: The bass boost performance  
will be dependent on the VOLUME  
control setting.  
Remove the disc  
Hold the edge and gently press the  
center pivot as illustrated, then pick  
up the disc.  
Turning Power on and off  
This unit has no ON / OFF switch.  
To turn on and off, press the  
following buttons.  
To turn on : Press  
PLAY/PAUSE  
( playback starts )  
To turn off : Press  
STOP button  
once for standby mode.  
Press STOP button  
again to turn off the power.  
TO PHONES SOCKET  
TO LINE OUT SOCKET  
Caution:  
Wait for the disc to stop rotating before  
pressing the OPEN button.  
Note:  
This unit can play 3 inch ( 8cm ) single  
CD’s without an adaptor. Do not use a  
CD single adaptor for these discs.  
Auto power-off function  
When the unit is stopped (standby  
mode ) for approximately 1 minute, the  
power is automatically turned off.  
EN-6  
EN-7  
 
LCD DISPLAY INFORMATION  
During STOP mode  
REPEAT / PLAY MODES  
Every time the MODE button is pressed, the corresponding mode appears in the  
display window, in the following sequence:  
The total number of tracks of the disc is  
displayed.  
NORMAL  
REPEAT 1  
REPEAT ALL  
Total no. of tracks.  
During PLAY mode  
The track number is displayed.  
MODE  
INTRO  
NOTE: In normal mode none of the above symbols show in the display.  
This fifth track.  
NORMAL PLAYBACK  
Press once to play  
During PAUSE mode  
When the track playback is paused, the track  
Play the whole disc.  
press  
number flashes.  
PLAY/PAUSE  
REPEAT 1  
During play  
Shown in the LCD display.  
Note:  
The current track on the disc  
will be repeated.  
When the lid is opened during play mode " - - " shows in the display indicating  
the door is open.  
press  
REPEAT ALL  
MODE  
Note:  
A flashing battery indicator  
be changed or recharged.  
appears in the display when the batteries need to  
Shown in the LCD display.  
All tracks on the disc will be  
During play  
repeated.  
x2 press  
MODE  
EN-8  
EN-9  
 
INTRO SCAN AND RANDOM PLAY  
PROGRAMMED PLAY AND SEARCH FUNCTIONS  
PROGRAM  
INTRO  
This allows selected tracks on the disc to be played in any desired order.  
Plays the first 10 second of each track on the disc.  
To set the program play  
Programs can be set in PLAY or STOP mode.  
During playback  
1. Press the PROG button.  
X3  
MODE  
Press  
The track number will appear in the display with  
PGM  
the  
indicator flashing.  
or to select the desired track.  
2. Press  
When in the STOP mode press the MODE button three times and then  
press the PLAY/PAUSE button to start INTRO playback.  
3. Press the PROG button to enter the track into  
the memory.  
4. Repeat step 2 and 3 to program up to 24 tracks  
memory.  
During disc playback press the MODE button three times and then press  
the back skip  
button to start INTRO playback. Alternatively INTRO will start  
5. Press  
to start the programmed play.  
at the end of the current playing track.  
6. To erase the program, press the STOP button once.  
RANDOM  
Locating a Particular track  
Enables all the tracks on a disc to be played in a Random ( RAND ) sequence.  
To skip back to the beginning of the  
Press  
lightly and repeatedly.  
lightly and repeatedly.  
current or a previous track  
For example : If "RAND" is selected while playing track 8, the random function  
will commence once track 8 has ended.  
When all tracks on a disc have been played the player will automatically stop  
and power down in approx. 1 minutes to preserve battery life.  
To skip to the beginning of the following  
Press  
tracks  
During play  
Locating a Particular Point in a track  
X1press  
RAND  
To search backward at a high speed  
To search forward at a high speed  
Keep  
Keep  
depressed  
depressed  
Press RAND button again to return to the NORMAL play mode.  
Note: Low level audio will be heard during the search process to assist in  
locating correct point in the track.  
EN-11  
EN-10  
 
TROUBLESHOOTING GUIDE  
PLAYER MAINTENANCE  
Cleaning the Cabinet  
Troubleshooting Guide  
Points to Check  
Wipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak  
solution of neutral detergent and water, and then wipe clean.  
Problem  
Cleaning the Lens  
Disc may be inserted upside down  
Disc not mounted correctly on chuck  
Dirty or defective disc  
A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not  
work. Open the disc cover and clean the lens as follows:  
Dirty pick up lens  
Player lid not closed  
Player fails to function  
Dust or Dry Particles  
Moisture/Condensation, allow player to warm up to  
room temperature for 60 minutes  
AC power to adaptor switched off  
Weak batteries  
Using a camera lens brush/blower, blow on the  
lens a couple of times, then wipe it lightly with  
he brush to remove dust. Then, blow on the  
lens once more.  
Auto switch off has occurred  
Finger prints  
Headphone plug is not firmly inserted into the  
Green Phones socket.  
Headphones have been inserted into the Black line  
output socket.  
No sound from  
Headphones  
If the lens cannot be cleaned by using a brush / blower,  
use a dry cotton swab starting in the middle and working to the outside edge.  
No sound when played  
through an external  
amplifier  
Connection is incorrect  
Cleaning the Disc  
Power to external amplifier not switched on  
When a disc becomes dirty, clean it  
with a cleaning cloth. Wipe the disc  
from the centre out.  
Dirty or defective disc  
Dirty pick up lens  
Player is subject to excessive vibration or shock  
Low battery power  
Poor Headphone connection  
Intermittent sound  
Note:  
Do not use solvents such as benzine petrol, thinner, commercially available  
cleaners or anti-static spray intended for analogue discs.  
EN-13  
EN-12  
 

Init Indoor Furnishings 09 0025 User Manual
Insignia Car Satellite TV System NS 20ED310NA15 User Manual
Intel Computer Accessories OPEN 660 120 140 150 II User Manual
Intel Computer Hardware 80302 User Manual
JVC Clock LYT1424 023A User Manual
JVC MP3 Player RC EX20A User Manual
Kambrook Electric Heater KRH500 User Manual
Kathrein Satellite TV System UFD 505 User Manual
Keys Fitness Home Gym A7e User Manual
Konica Minolta Oxygen Equipment PULSOX 300 User Manual